speedo cable installation

If you're having a problem with your scoot, drop us a line!

Moderator: Tuna Cowboy

speedo cable installation

Postby Grahamcracker » Sun Aug 19, 2012 3:08 pm

Got the cable routed easily enough, but the square section that goes into the front hub doesn't seem to want to go in far enough/stay in place. Any recommendations? Cheers
Grahamcracker
 
Posts: 247
Joined: Tue Aug 09, 2011 10:20 pm

Re: speedo cable installation

Postby Gearless42 » Sun Aug 19, 2012 3:38 pm

you need to get the rubber grommet on the cable outer. feed the square end of the cable into the hub and spin the tire while pressing in on the end that feeds into the speedo. should slip in farther and begin to rotate with the tire. then make sure to get the retention plate bolted back down over the grommet.
If you keep fiddling with it, it's going to fall off...
~Landon
User avatar
Gearless42
 
Posts: 579
Joined: Sat Sep 25, 2010 11:21 am
Location: Eugene, Or


Return to Scooter Workshop

Who is online

Users browsing this forum: No registered users and 5 guests

cron